Plasma Nano Alumina-Titania

A&A Coatings Plasma sprayed Nano Alumina-Titania was developed to produce extremely wear resistant ceramic coatings which take excellent finishes. The coatings are heat resistant to about 540°C (1000°F), are resistant to most acids and alkalies, and have high dielectric strength.Coatings of Nano Alumina-Titania are very dense, and exhibit little evidence of through porosity when sprayed .25-.38mm (.010-.015″) thick. Bond strength is high, interparticle bond is high, and a very smooth finish can be obtained. The coatings resist heat to about 540°C (1000°F). They resist corrosion by dilute solutions of alkalies. They also resist wetting by common aqueous solutions. (Coatings of other ceramics absorb these liquids.)

Material Powder Characteristics

Typical Composition: Nano Titanium Dioxide (13%)
Nano Aluminum Oxide (Balance)
Typical Size Range: -270 mesh +15 microns
-53 +15 microns
Melting Point: 1840°C (3340°F)

Physical Properties of Coating

Texture, as sprayed, (microinches aa): 250 – 350
Finish, ground (microinches aa): 10 – 20
Finish, Lapped (microinches aa): 2 – 4
Macrohardness: Rc63
Cross-Sectional Hardness (DPH300): 850 – 1000
Dielectric Strength (Volts/Mil): 300
Density (g/cc): 3.5
Coating Weight (lb/ft2/.001″): .018
Bonding: > 3,000psi (without bond coat)

The porosity of all coatings of A & A Company Plasma sprayed Alumina-Titania is negligible. Sealing of coatings recommended for corrosive chemical environments. However, unsealed coatings were exposed to 2% salt solution for five weeks with no indication of penetration to the base material.

Thickness Limitation

A&A Coatings Plasma Sprayed Nano Alumina-Titania was designed for use in thin coatings, not more than 0.5mm – 0.63mm (0.020″ – 0.025”) thick. If sprayed thicker, the probability of cracking and delamination will increase rapidly, as is the case of thick coatings of all fine powders.

Service Temperature

A&A Coatings Plasma Sprayed Nano Alumina-Titania should not be used at temperatures above 540°C (1000°F). At temperatures higher than 540°C (1000°F), the coating undergoes a phase transformation resulting in embrittlement and cracking.

Surface Preparation

A&A Coatings Plasma Sprayed White Nano Alumina-Titania can be applied to most substrates which have been cleaned to remove surface oxides. This cleaning is accomplished with a light grit blast. Additionally, a “Bond coat” is required in most cases. Please contact us for substrate specific requirements

Finishing

A&A Coatings Plasma Sprayed Nano Alumina–Titania can be ground to required finish size and polished to a 6 – 8 surface finish.

Request A Quote

Please complete this form and you will be contacted within the same business day.

  • Max. file size: 2 MB.